The low output of feed pellet making machine affects the working efficiency. How to improve the output? This paper will discuss in detail what factors affect the output of straw feed granulator. First of all, make sure that the user uses it correctly according to the instructions. Secondly, the output of granulator equipment produced by some small manufacturers can not meet the said standard, so it is recommended that users choose regular large straw granulator manufacturers for purchase. In fact, there are many factors that affect the output of straw feed granulator. Now let's talk about the external factors that have nothing to do with the granulator.
1. Raw material factor: generally, the larger the volume of raw materials, the higher the grain production. The raw material has fine particle size and high grain yield, but it affects the forming rate of particles. If the material level is adjusted too much, the wear between die plate and roller will be increased, the energy consumption will be increased and the output will be reduced gradually.
2. Raw material moisture control: too high adjustment of raw material moisture will cause the raw material to slip between the die plate and the pressing roller, resulting in the blocking of the die hole. Generally, the moisture content should be below 14%, otherwise, the low moisture content will also cause the low molding rate.
3. Incorrect operation method: after adjusting the water content, it can be judged by holding it in groups and releasing it. If the water content is adjusted to be more than 18%, the material is easy to slip between the inner wall of the die plate and the pressing roller, and even will not produce particles, reducing the output. If the adjustment is too low, the yield will also be reduced, and the most suitable water content should be adjusted between 15-16%. Specific needs the user to carry on the test by himself, practice makes perfect.
4. The distance between the press roll and the die plate, and the gap between the press roll and the die plate is too large or too small, will also be affected. Generally, the manual turning is used for one week, and it is better to adjust the gap to a distance of 0.05-0.3mm.
5. Quality of die plate: the smoothness of die plate die hole will also affect the production. If some iron chips or foreign matters are attached to the new die plate die hole, please remember to polish before use to reduce the friction resistance and improve the production output.
6. Other factors: for example, voltage instability, current, feed stability will affect the output.
