Reasons for failure of straw feed pellet machine:
1. The first use of flat die has poor hole;
2. Material moisture content is too high or too low;
3. The gap between pressing roller and flat die is too large;
4. The press roll or die plate are seriously worn;
5. V-belt slipping or aging
Removal method of straw feed pellet machine:
1. Grind and lubricate with oil, and the output will increase after working for a period of time;
2. Adjust the moisture content of materials
3. Adjust the compression bolt;
4. Replace roll or die plate
5. Tension or replace the V-belt
Straw feed pellet machine failure
1. High water content;
2. The flat die is used for the first time.
Removal method of straw feed pellet machine
1. Reduce water content
2. Repeatedly grind with oil
The reasons are as follows: 1. the moisture content is low; 2. the flat die is excessively worn and the thickness is too small.
Elimination methods: 1. Increase water content; 2. Replace new flat die
Cause of failure
1. Falling into hard debris; 2. Bearing damage; 3. Loose parts
Elimination method
1. Stop the machine to remove foreign matters; 2. Replace the bearing; 3. Fasten the parts.
